BMS alpha CR - Work Operation Prep: Hydraulic Oil Level

7
Work mode
7.5
Prepare work operation
88
4. Check the oil level on the diesel motor. Proceed as follows:
Figure 44: Check hydraulic oil level
− Pull out the dipstick (3) when cold and wipe it with a lint-free cloth
or absorbent paper.
− Then insert the dipstick (3) and pull it out again.
− Carry out a visual inspection of the dipstick (3). The hydraulic oil
must be between the MIN and MAX marks. If the level is close to
MIN or below MIN, a corresponding quantity of hydraulic oil must
be topped up via the filler neck (4).
➢ The hydraulic oil must not exceed the MAX mark.