If necessary, the work lamp can be switched on. The switch for the work
lamp is located in the motor compartment.
When the work lamp is switched on, make sure that it is switched off at
the end of work, otherwise there is a risk of battery discharge.
1. Close the machine cover.
2. Make sure that the emergency stop button is unlocked.
3. Switch on the voltage supply via the "Control unit on" switch.
4. Press the "Start/stop motor" button on the control panel.
Press the button until the motor runs. This can take a few seconds
depending on the outdoor temperature.
➢ If the motor switches off after the button is released, repeat the
starting procedure a few times. Depending on the outside
temperature (minus temperatures), max. 5 times.
If the motor continues to stop after this, check the fuel level,
compressor oil and motor oil level and the indicator lights on the
multifunctional display again. If everything is in order, contact the
service personnel.
➢ After replacing the pre-filter or after a long period of machine
downtime, starting problems may occur due to a lack of fuel
supply.
To Next Page
Loading...