Illustrations (continued)
Figure Title Page
6-3 Fit insulation jackets 6-7
6-4 Clean the exhaust check-valve 6-8
6-5 Try to turn the HCDP pump 6-18
6-6 System lockout/tagout procedures 6-19
Tables
Table Title Page
1-1 Safety sensors 1-22
2-1 Technical data 2-2
2-2 Full load current ratings 2-15
2-3 Nitrogen purge flow rates: high gas configuration 2-16
2-4 Electrics box default setpoints 2-17
2-5 Electronics module default setpoints 2-17
2-6 Gas module default setpoints: high gas configuration 2-18
2-7 Test parameters 2-19
2-8 Test results 2-19
3-1 Installation checklist 3-2
3-2 Checklist of components 3-4
3-3 Pins in the iH tool interface module connector plug 3-20
3-4 Pins in the electrical supply connector 3-27
4-1 Menu structure 4-5
5-1 Configuration store nominal gas flows 5-4
5-2 Status menu sensor reading displays 5-10
6-1 Warning messages 6-21
6-2 Alarm messages 6-26
6-3 Fault messages 6-28
6-4 Fault parameters 6-29
6-5 Fault types 6-30
iH Dry Pumping Systems vii
To Next Page
Loading...
