Functions and operation
EN
116 bora.com
5.5.4
Switching the fan off
Switching the fan off
u
Swipe downwards to power level 0
or
u
tap until power level 0 is reached
or
u
long press on the fan button
or
u
Long press on the fan power level in the multi-
function display.
T
the automatic after-run function is started.
5.5.5
Automatic after-run
The cooktop extractor continues to run at a lower level
and switches off automatically after a defined time. The
duration of the after-run function can be set in the
menu (10, 15 or 20 minutes ). The default duration of
the after-run function is 20 minutes.
T
When the extractor is switched off, the automatic
after-run function is activated.
T
Once the automatic after-run period has lapsed, the
cooktop extractor switches itself off.
Switching off the automatic after-run early
u
Long press on the fan button
T
The cooktop extractor after-run function is switched
off.
BORA expressly recommends use of the
cooktop extractor after-run function.
5.5.6
Filter service display
The cooktop extractor filter service display is
automatically activated when the end of the activated
charcoal filter service life is reached (only in
recirculation mode).
T
is displayed in the multi-function display.
T
The filter service display is shown every time the
cooktop extractor is switched on and remains active
until the filter has been changed and the filter service
display has been reset (see"6.3Menu item 3: Show
filter status and reset filter service display").
T
The cooktop extractor can still be operated without
limitations.
The components of the grease filter require
regular cleaning regardless of the filter service
display, see “8 Cleaning and Maintenance”.
5.6
Cooktop functions
5.6.1
Pan size recognition
On induction cooktops the cooking zone recognises the
size of the cookware automatically and only targets the
energy at that area. It also recognises cookware that is
unsuitable or too small, or if there is no cookware
present. A cooking zone is not working if / are
alternated in the display. This happens if
T
it is switched on without cookware or with unsuitable
cookware;
T
the base diameter of the cookware is too small;
T
the cookware is removed from a switched-on
cooking zone.
If no pot is recognised 10 minutes after setting a power
level, the cooking zone will switch off automatically.
Permanent pan size recognition
The appliance automatically recognises cookware and
activates the corresponding cooking zone controls.
Manual selection of the cooking zone is not necessary
(see"6.7Menu item 7: Permanent pan size
recognition").
Do not simply rely on the pan size recognition
function on induction cooktops; always switch
the appliance off after use.
5.6.2
Selecting a cooking zone
u
Tap the cooking zone display.
T
is displayed in the cooking zone display.
T
The additional cooking zone functions appear.
T
The cooking zone controls are activated for 2
seconds and you can apply settings to the chosen
cooking zone.
u
Repeat this process to operate further cooking zones
if necessary.
To Next Page
Loading...
Need help?
General
