Cleaning and maintenance
EN
132 bora.com
u
Take hold of the end of the activated charcoal filter
and pull upwards and towards the left until it is
completely out of the inlet opening.
Fig.7.7
Taking the activated charcoal filter out of the
inlet opening
Inserting the activated charcoal filter
u
Remove the packaging from the activated charcoal filter.
u
Position the activated charcoal filter correctly with the
help of the printed symbols (arrow left, grip strap right).
u
Hold the activated charcoal filter at both ends.
u
Bend the activated charcoal filter into a cylindrical shape
so that both ends of the filter are opposite each other.
Fig.7.8
Activated charcoal filter
[1]
Activated charcoal filter
[2]
Grip strap
u
Tilt the activated charcoal filter towards you slightly
and insert it through the inlet opening.
u
Guide the left end of the filter into the opening in the
filter housing.
Fig.7.9
Inserting the activated charcoal filter through
the vent opening
u
Push the activated charcoal filter into the filter
housing until it will go no further (to do this, you can
place one finger between the slats and gradually
push the filter into the housing).
T
The end position of the activated charcoal filter is
reached when the filter has been fully pushed inside
the filter housing.
Fig.7.10
Placing the activated charcoal filter in the end
position
u
Inside the inlet opening push the filter replacement cover
until it comes to a stop in the filter housing opening.
u
Check that the filter replacement cover is positioned
correctly.
Fig.7.11
Inserting the filter replacement cover
To Next Page
Loading...
Need help?
General
