Tutorial Guide
The following pages provide step-by-step instructions for creating and printing labels using a
variety of different printer functions.
The part number of the marker roll used is noted at the beginning of each tutorial. Many of the
tutorials use part number PTL-19-423. A sample roll of this 1" x 1" marker is provided in your
TLS2200
™
Thermal Labeling System package.
T1: Creating a One-Line Legend, Component Marker
Note: This example assumes you have marker roll PTL-19-423 loaded in your printer.
Label to be printed:
100A
Setup Status:
Center
H Justify
Center
V Justify
0 Degrees
Rotation
Component
Format
1. Check the Status Bar to make sure the unit is in Component mode. If not, press <Shift>
+ <Wire> to toggle from Wiremarker mode to Component mode.
2. Enter 100A on line one (font is set at default size – 9).
3. Press <Print>.
38 TLS2200
™
Thermal Transfer Printer User Manual
To Next Page
Loading...
Need help?
General
