Brady TLS2200 - T4: Creating Serialized Wiremarkers

To Next Page

To Previous Page

T4: Creating Serialized Wiremarkers

Note: This example assumes you have marker roll PTL-19-423 loaded in your printer.

Labels to be printed:

A201

A205

Setup Status:

Center

H Justify

Center

V Justify

0 Degrees

Rotation

Wire

Format

1. Press <Legend Clear> to clear the text from line one.

2. Check the Status Bar to make sure the unit is in Wiremarker mode. If not, press

<Shift> + <Wire> to toggle from Component mode to Wiremarker mode.

3. Enter A201 on line one.

4. Press <

◄> to position the cursor under the last character.

5. Press <Func> + <Serial>.

6. When “No. to Serial?” prompt appears, enter 5, then press <Enter>.

7. When “No. of Copies?” prompt appears, enter 2.

8. Press <Enter> or <Print>. The printer begins printing two each of the five

wiremarkers listed above.

TLS2200

™

Thermal Transfer Printer User Manual 41

Other manuals for Brady TLS2200