brielmaier S250 - Cleaning the Intake Manifold and Engine Oil Cooler; Greasing the Lubrication Points

7 | Maintenance Brielmaier Motormäher GmbH
82 BA Motor mower S250 (Version 2021/09)
NOTICE
Damage due to contamination!
If dirt enters the combustion chamber of the engine, there is a risk of
damage to equipment.
4 Pay attention to cleanliness when cleaning.
4 Make sure that no dirt enters the combustion chamber of the engine.
3
c) Clean the air filter (3) and foam filter.
4
5
d) Attach the air filter housing (4).
e) Close the air filter housing (4) with the screw cap (5).
7.5.4 Cleaning the intake manifold and engine oil cooler
1
2
a) Check the engine oil cooler (2) and intake manifold (1) regularly for
dust-intensive work.
b) Clean if necessary.
7.5.5 Greasing the lubrication points
The following lubrication points are located on the machine:
– All links and tension levers of the handlebars
– Telescopic tube on the handlebars
– Axle and ball-locking pin on running board
Lubricate all lubrication points with suitable lubricants (multi-oil / grease)
before use.
NOTE
Grease the lubrication points of the attachment according to the
instructions in the relevant instructions.