brielmaier S250 - Switching the Direction of Travel; Using Attachments

Brielmaier Motormäher GmbH Operating the machine | 5
BA Motor mower S250 (Version 2021/09) 65
5.8.6 Switching the direction of travel
When switching the direction of travel:
– The machine slows down to a standstill.
– The direction of travel is changed.
– The machine is accelerated back to the previous speed.
NOTE
The machine can only be driven backwards at speed levels 1 and 2. In
speed level 3, there is an automatic change to speed level 2.
1
2
1
To change the direction of travel:
a) Briefly press the direction of travel button (1).
ð The machine drives in reverse continuously.
or
a) Keep the direction of travel button (1) pressed.
ð The machine continuously drives in reverse as long as the button is pressed.
5.9 Using attachments
The attachment can be switched on while driving or when the machine is
stationary.
There are two different operating modes for this purpose, depending on
the type of attachment:
– Quick start: Only for mowing units. Overload protection (pressure limit
180 bar) active.
– Soft start: For all attachments except mowing units. No overload
protection (maximum pressure 260 bar)
Quick start
For a quick start:
1
2
a) Briefly press the "attachment ON/OFF" button (1) to switch on the
attachment.
3
ð The "Attachment drive quick start/pressure limit active" symbol (3) appears
on the display (2).
4
b) Adjust the speed of the engine with the throttle lever (4).