brielmaier S250 - Removal and Disposal; Safety During Removal and Disposal; Removal Work

Brielmaier Motormäher GmbH Removal and disposal | 9
BA Motor mower S250 (Version 2021/09) 99
9 Removal and disposal
9.1 Safety during removal and disposal
SAFETY INSTRUCTIONS
Work safely during removal and disposal!
Carry out all work in compliance with the safety instructions listed
below:
4 Comply with the regulations listed in the chapter Safety [}21] Comply
with the regulations listed in the chapter
4 Do not work in any way that could endanger safety.
4 Carry out the work in accordance with the requirements in these
instructions.
4 Comply with the relevant national regulations concerning
occupational safety.
4 Always wear the personal protective equipment required for the
respective tasks.
4 Switch off the drive system and secure it against being switched on
again (switch off and remove the battery disconnector) before
starting work.
4 Do not stand or work beneath suspended loads!
NOTICE
Environmental hazard from leaking operating materials.
Leaking oil and other operating materials can pollute the environment.
4 If environmentally hazardous substances are accidentally released into
the environment, take appropriate measures immediately. In case of
doubt, inform the responsible local authority of the damage.
4 Observe the product data sheets for operating/auxiliary materials.
4 Always comply with the local applicable legal regulations concerning
environmental protection.
9.2 Removal work
1. If necessary, disconnect the machine from the attachment and secure it
to prevent it from rolling away.
2. If necessary, dismantle the components further in compliance with the
applicable local occupational safety and environmental protection
regulations.
3. Remove all residual grease from the individual parts.