Brother DCP-8065DN

App. 3-1 Confidential
EEPROM CUSTOMIZING CODES
This function allows you to customize the EEPROM according to language, function settings, and
firmware switch settings.
Operating Procedure
(1) Press the [Menu] and [Start] keys. Next press the [
] key four times to make the machine
enter the maintenance mode.
TIP: FAX models equipped with numerical keypads can enter the maintenance mode in the
same way as conventional models; that is, by pressing the [Menu], [*], [2], [8], [6] and
[4] keys in this sequence.
The machine beeps for approx. one second and displays “
” on the
LCD.
(2) Press the [7] and [4] keys in this order in the initial stage of the maintenance mode.
The current customizing code (e.g., 0002 in the case of DCP-8060 Canada model) appears.
(3) Enter the desired customizing code (e.g., 0001 in the case of DCP-8060 U.S.A. model). The
newly entered code appears.
To enter letters “A” through “F”, press the [1] through [6] keys while holding down the
[#] key, respectively.
NOTE: If a wrong 4-digit code is entered, the machine will malfunction.
(4) Press the [Start] key.
The machine saves the setting and returns to the initial stage of the maintenance mode.
If you press the [Stop/Exit] key or no keys are pressed for one minute in the above procedure,
the machine stops the procedure and returns to the initial stage of the maintenance mode.