1-5 Confidential
< Status LED indications >
The Status LED (Light Emitting Diode) will flash and change color depending on the machine status.
Fig. 1-5
The LED indications shown in the table below are used in the illustrations in this chapter.
LED LED Status
LED is off.
Green
Yellow
Red
LED is on.
Green
Yellow
Red
LED is blinking.
LED Machine Status Description
Sleep Mode The power switch is off or the machine is in Sleep
mode.
Green
Warming Up The machine is warming up for printing.
Green
Ready The machine is ready to print.
Yellow
Receiving Data The machine is either receiving data from the
computer, processing data in memory or printing
data.
Yellow
Data Remaining in Memory Print data remains in the machine memory.
Red
Service error Follow the steps below.
1. Turn off the power switch.
2. Wait a few seconds, and then turn it back on and
try to print again.
If you cannot clear the error and see the same
service call indication after turning the machine
back on, please call Brother Customer Service.
To Next Page
Loading...
