Brother DCP-8065DN

Confidential
9-8
Error Code
(Hex)
Symptom Probable Cause
Solution
The paper trays T1 and T2
are mounted oppositely.
Switch the paper trays T1
and T2.
Foreign materials between
the tray and front
registration sensor
Remove foreign materials.
PF roller defective Replace the PF roller.
Separation pad ASSY
defective
Replace the separation
pad ASSY.
T2 solenoid defective Replace the T2 solenoid
Regist actuator front does
not move smoothly.
Set the regist actuator
front into place.
Regist actuator front
defective
Replace the regist actuator
front.
Regist front sensor
defective
Replace the high-voltage
PS PCB.
8A Jam tray2
Main PCB defective Replace the main PCB.
Foreign materials between
the tray and front
registration sensor
Remove foreign materials.
PF roller defective Replace the PF roller.
Separation pad ASSY
defective
Replace the separation
pad ASSY.
T1 solenoid defective Replace the T1 solenoid.
Regist actuator front does
not move smoothly.
Set the regist actuator
front into place.
Regist actuator front
defective
Replace the regist actuator
front.
Regist front sensor
defective
Replace the high-voltage
PS PCB.
8B Jam tray1
Main PCB defective Replace the main PCB.
MP tray defective Replace the MP tray.
PF roller defective Replace the PF roller.
Separation pad ASSY
defective
Replace the separation
pad ASSY.
MP solenoid defective Replace the MP solenoid.
Regist actuator front does
not move smoothly.
Set the regist actuator
front into place.
Regist actuator front
defective
Replace the regist actuator
front.
Regist front sensor
defective
Replace the high-voltage
PS PCB.
8C Jam MP tray
Main PCB defective
Replace the main PCB.
8D-A0 Not used.