Brother MFC-9560CDW - Page 112

2-73
Confidential
■ Error code 90
The paper size of the MP tray does not match that of the print setting.
Error code 91
The paper size of the paper tray 1 does not match that of the print setting.
Error code 92
The paper size of the paper tray 2 does not match that of the print setting.
Error code 93
No paper in MP tray.
Error code 94
No paper in paper tray 1.
Error code 95
No paper in paper tray 2.
Error code 96
No paper in all trays.
This error does not usually occur in the normal use. The conceivable causes are noise around
the installation site, fluctuation of the power supply voltage, and failures in the software.
<User Check>
- Turn OFF the power switch, and turn it ON again after a while.
Size Mismatch
Reload correct paper.
Size Mismatch
Reload correct paper.
Size Mismatch
Reload correct paper.
No Paper
Reload paper in MP Tray.
No Paper
Reload paper in Tray 1.
No Paper
Reload paper in Tray 2.
No Paper
Load <size> paper in Tray.
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.