Brother MFC-9560CDW - Ncu Pcb Assy

3-134
Confidential
9.39 NCU PCB ASSY
(1) Remove the Screw pan (S/P washer) M3.5x6 screw to remove the NCU FG harness
ASSY from the Main body.
(2) Disconnect the Connector (CN9) from the Main PCB ASSY.
(3) Disconnect the wiring from the Main PCB ASSY.
Fig. 3-190
(4) Remove the two Taptite bind B M4x12 screws to remove the NCU unit from the Main body.
Fig. 3-191
Memo:
Follow the procedures (5) to (7) in the case of the Legal model.
Screw pan (S/P washer) M3.5x6
Main body
NCU FG harness ASSY
Connector
CN9
Main PCB ASSY
Taptite bind B M4x12
NCU unit
Main body