Brother MFC-9560CDW - Print Crease

2-126
Confidential
■ Print crease
■ Spots at the rear edge of paper
Fig. 2-19
<User Check>
- Check the machine’s environment, conditions such as high humidity
may cause this situation to occur.
- Change the paper to thick paper.
- Check if paper is not damp.
Step Cause Remedy
1 The pressure of the pressure
roller is high
Change the position of the PR arm covers.
(Refer to the figure below.)
2 Fuser unit failure Replace the fuser unit.
<User Check>
- Check the machine’s environment, conditions such as high humidity
may cause this situation to occur.
Step Cause Remedy
1 The pressure of the pressure
roller is high
Change the position of the PR arm covers.
(Refer to the figure below.)
2 Fuser unit failure Replace the fuser unit.
PR arm cover
PR arm cover
Envelope lever
Envelope lever
<Back side>