5-15
Confidential
* For more information on the worker switch, refer to Appendix.
<Operating procedure>
(1) Press the 1 and 0 buttons in this order in the initial state of the maintenance mode.
The machine displays "WSW00" on the LCD and becomes ready to accept a worker
switch number.
(2) Enter the desired number from the worker switch numbers (01 through 78). The following
appears on the LCD.
(3) Enter a value to be set (0 or 1) using the 0 and 1 buttons.
(4) Press the OK button. This operation saves the newly entered selector values onto the
EEPROM and readies the machine for accepting a worker switch number.
(5) Repeat steps (2) through (4) until the modification for the desired worker switches is
completed.
(6) When the Stop/Exit button is pressed, the machine beeps for one second and returns to
the initial state of the maintenance mode.
WSW68 Reserved (Change of the setting is prohibited)
WSW69 Reserved (Change of the setting is prohibited)
WSW70 Reserved (Change of the setting is prohibited)
WSW71 Reserved (Change of the setting is prohibited)
WSW72 Reserved (Change of the setting is prohibited)
WSW73 Reserved (Change of the setting is prohibited)
WSW74 ADF stop control
WSW75 Paper feeding parameter for turning the document counter when the
machine takes action duplex scanning
WSW76 The limited number of the documents in reverse for paper ejection of the
simplex scanning from ADF
WSW77
The limited number of the documents in reverse for paper ejection of the
duplex scanning from ADF
WSW78 Recording stop function when the drum reaches the end of life
WSW79 Function setting 27
Memo:
- To cancel this operation and return to the machine to the initial state of the maintenance
mode during the above procedure, press the Stop/Exit button.
- If there is a pause of more than one minute after a single-digit number is entered for
double-digit worker switch numbers, the machine will automatically return to the initial
state of the maintenance mode.
WSW No. Function
Selector 1 Selector 8
To Next Page
Loading...
