Brother MFC-9560CDW - Engine PCB ASSY

3-147
Confidential
9.47 Engine PCB ASSY
(1) Disconnect the seventeen Connectors (CN3, CN5, CN8, CN9, CN10, CN11, CN12,
CN13, CN14, CN16, CN17, CN18, CN19, CN20, CN21, CN22, and CN23) and four Flat
cables (CN1, CN2, CN15, and CN25) from the Engine PCB ASSY.
Fig. 3-213
(2) Remove the three Taptite cup S M3x6 SR screws to remove the Engine PCB ASSY from
the Top drive ASSY.
Fig. 3-214
Note:
- After disconnecting flat cable(s), check that each cable is not damaged at its end or
shortcircuited.
- When connecting flat cable(s), do not insert them at an angle. After insertion, check
that the cable are not at an angle.
CN12
CN11
CN9
CN13
CN14
CN10
CN8
CN5 CN3 CN2 CN1
CN15
CN25 CN23 CN22 CN21 CN20 CN19 CN18 CN17 CN16
Engine PCB ASSY
Taptite cup S M3x6 SR
Top drive ASSY
Engine PCB ASSY
<Left side>
Taptite cup S
M3x6 SR