2-24
Confidential
3.2 Error Messages
The error messages displayed on the LCD of the machine and their description are shown in
the table below.
Error message Description
Error
codes
Refer
to:
Access Error
The USB device is taken out while data is
being processed.
--- 2-140
Calibrate
(Calibrate Failed)
Incorrect density sensor measurement
value when implementing adjustment of
color density.
81 2-65
Density patch measurement is not
completed normally when implementing
adjustment of color density.
82 2-65
Toner of the color which is being used
reaches the end of life when implementing
adjustment of color density.
87 2-68
Cartridge Error
Failure to detect a new black toner
cartridge.
C0 2-86
Failure to detect a new yellow toner
cartridge.
C1 2-86
Failure to detect a new magenta toner
cartridge.
C2 2-86
Failure to detect a new cyan toner
cartridge.
C3 2-86
Condensation
Condensation occurred on the laser unit. 1A 2-36
Connection Error
Connection Fail
FAX communication error. --- 2-140
Cooling Down
Cooling down the inside of the machine to
protect it.
75 2-60
Cover is Open
The front cover is open. A1 2-77
The fuser cover is open. 56 2-51
DIMM Error
Defective DIMM is installed. C9 2-89
Disconnected
FAX connection error. --- 2-138
Document Jam
The document was not inserted, or fed
properly.
A2,
A3
2-77
2-78
Drum Error
Dirt on drum unit. 7D 2-61
Drum Stop
Drum unit error. (An drum error occurred
after the drum unit reached the end of life.)
83 2-66
Duplex Disabled
The back cover is open upon duplex
printing. (The back cover sensor is OFF.)
0F
16
2-32
2-34
To Next Page
Loading...
