2-23
Confidential
CE The waste toner box is not
installed.
2-91
CF Waste toner box full. (The
sensor detects that the waste
toner is full.)
2-91
D0 Touch panel initialization failure. 2-92
D1 Modem initialization failed. 2-92
D2-
DC
Modem error. 2-92
DE When the center thermistor is
higher than the idle temperature,
it is detected that the side
thermistor temperature is lower
than 60 °C.
2-93
DF FAX communication error of
main PCB.
2-93
E0
Program error. (An error occurred
in the ROM checksum.)
2-93
E1 Program error. 2-94
E2 When the center thermistor is
lower than the idle temperature,
it is detected that the side
thermistor temperature is higher
than 280 °C.
2-94
E3 Drum position sensor error. 2-94
E4 Run out of paper. 2-95
E6 Write error in EEPROM of the
main PCB.
2-95
E7 Main PCB error. 2-95
E8 The scanned data fails to be
recorded in the buffer RAM.
2-96
E9 Main PCB error. 2-96
EA Communication data error upon
scanning.
2-96
Error
codes
Problem
Refer
to:
EB Read error in EEPROM of the
laser unit.
2-97
EC Fuser fan error. 2-97
ED Communication with the
wireless LAN PCB cannot be
established upon startup of the
power supply.
2-97
EE Unavailability of communication
after connecting to the wireless
LAN PCB is detected.
2-98
EF The supplied power is unstable. 2-98
F0 USB flash memory does not
work properly.
2-99
F1 The dial number is not found.
2-99
F2 The waste toner box will reach
the end of life soon.
2-99
F3 Main PCB error.
2-100
F4 The waste toner box is at the
end of life.
2-100
F5 Main PCB communication error.
2-100
F6 P.C. I e rr o r.
2-100
F8 Battery connection error.
2-100
F9 The country code is not entered
properly.
2-101
FA
The black drum unit is not installed.
2-101
FB
The cyan drum unit is not installed.
2-101
FC The magenta drum unit is not
installed.
2-101
FD
The yellow drum unit is not installed.
2-101
FE Detection of incorrect
measurement value of density
sensor sensitivity calibration.
2-102
FF Wireless LAN module
overcurrent error.
2-102
Error
codes
Problem
Refer
to:
To Next Page
Loading...
