3-151
Confidential
(9) Disconnect the Connector (CN8) and two Flat cables from the Laser unit to remove the
Laser unit from the Base frame unit.
Fig. 3-221
Fig. 3-222
Harness routing: Refer to “ Laser Unit”
Note:
After disconnecting flat cables, check that each cable is not damaged at its end or
shortcircuited.
Assembling Note:
- When connecting flat cables, do not insert them at an angle. After insertion, check that
the cables are not at an angle.
- When the flat cables of the Laser unit are replaced, be sure to fold and assemble the Flat
cable as shown in the figure.
Base frame unit
Laser unit
Connector
9a
9b
<Front>
Laser unit-Main flat cable
9a
Laser unit-Engine
flat cable
Fold down FFC along with the solid line
Fold up FFC along with the dotted line
45°
10
(mm)
<Laser unit-Main flat cable>
<Laser unit-Engine flat cable>
90 133 163 175 215
43 3080 4012
45°
45°
10 40 95 137 182
5530
215
4542
To Next Page
Loading...
