Brother MFC-9560CDW - Page 584

App.2-1
Confidential
APPENDIX 2 DELETION OF USER SETTING INFORMATION, ETC.
In this machine, the user setting information is stored in the EEPROM and flash memory of the main
PCB. You can delete all the data listed below at a time with the procedure given below.
- Information related to Net
- User setting information
<Operating procedure>
(1) Press the Menu button while the machine is in the ready state.
Non Touch panel model
(2) Press the or button, then the "Initial Setup" or "General Setup" will appears on the LCD
and press the OK button.
(Which will appear, "Initial Setup" or "General Setup", depends on the model.)
(3) Press the or button, then the "Reset Menu" will appear on the LCD and press the OK
button.
(4) Press the or button, then the "All Settings" will appear on the LCD and press the OK
button.
(5) The "1.Reset 2.Exit" appear on the LCD.
(6) Press the 1 button, and the user setting information is deleted, and the machine goes back to
the ready state.
Touch panel model
(2) Press "Initial Setup" or "General Setup" on the LCD.
(3) Press "Reset" on the LCD.
(4) Press "All Settings" on the LCD.
(5) "Reset? All Settings? Yes/No" will appear on the LCD. Press "Yes".
(6) "Reboot OK? Press for 2 second to confirm. Yes/No" will appear on the LCD. Press "Yes" for 2
seconds or longer, the user settings are cleared, and the machine returns to the ready state.
Note:
The machine returns to the ready state automatically if no panel operation is implemented for 30
seconds.