Section 03 ENGINES
Subsection 06 (BOTTOM END)
A32CC4B
Slide-in the second bearing until it contacts the
first one.
A32CC5B
Crankshaft Installation
At crankshaft installation, position drive pins as il-
lustrated.
1
A32C1CA
TYPICAL
1. Position pins
Pour 50 mL (2 U.S. oz) of injection oil in the pan
under central gear to lubricate pump gearing as
per photo.
1
A32C0DA
1. Oil bath
Apply Isoflex grease as per following procedure:
CAUTION: Use only the recommended Isoflex
grease. Make sure not to push Isoflex
grease between outside bearing race and
half crankcase.
NOTE: The 50 g tube corresponds to 50 cc of
grease.
Put50to55mLofgreaseinasyringe.
CAUTION: Do not exceed the recommended
amount of grease
Fill inner side of PTO side bearing with Isoflex
grease (about 10 mL).
126 mmr2005-073
To Next Page
Loading...
