9 – 8 Repair Manual RRE140/160/180/200/250 © BT
Motors 1000
Steering motor and steering unit (1730)
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
9.3.3 Removing the steering motor from the
truck
1. Prepare the truck for servicing and open the motor compartment.
2. Disconnect the connector unit from the steering motor. The con-
nector unit is locked with a catch (arrow) that must be pressed out
before the connector unit can be undone.
3. Remove the three mounting screws (8 mm allen screws) of the
steering motor.
4. Remove the motor. The motor bracket has a guide pin (a) that can
jam when removing the motor. Use M10 screws as a puller in the
threaded holes if the motor gets jammed.
9.3.4 Placing the steering motor in the truck
1. Clean the guide pin hole in the motor bracket and place the motor.
Tightening torque 45 Nm.
2. Connect the connector unit for the steering motor and press the
locking catch in.
a
To Next Page
Loading...
