13 – 4 Repair Manual RRE140/160/180/200/250 © BT
Electrical system 5000
Control console (5510)
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
13.2.3 Removing the control console from the
truck
1. Remove the armrest (a) and the box (b) under the armrest.
2. Undo the two contacts (c) under the armrest.
3. Remove the cable clamp (d) (10 mm hex).
4. Press in the catch (e) on the control console's side and push the
console into its rear position.
5. Rotate the catch (f) out, so that it points straight out of the control
console.
6. Release the control console by lifting it straight up. Take care that
the catch does not break off.
7. Remove the control console with its attendant wiring harness; be
careful with the connector units.
a
b
c
d
e
f
To Next Page
Loading...
