Hydraulic system 6000
Main lift cylinder (6610)
Publication No. Date Valid from serial number T-code
261828-040 2008-08-21 6051502 815, 816
© BT Repair Manual RRE140/160/180/200/250 14 – 19
14.5.3 Fitting the cylinder to the mast
1. Lift the cylinder into the mast.
2. Fasten the cylinder onto the bottom stud.
3. Fit the cylinder support.
4. Using blocks, chock up the inner runner approximately 50 cm
above the floor.
5. Lower the mast.
6. Connect the hydraulic hose to the cylinder.
7. Raise the forks until the lift cylinder makes contact with the top
beam.
8. Fasten the cylinder to the top beam.
9. Lower the forks to the bottom.
10. Fit the chain wheel and lifting chain.
11. Adjust the chain so that the mast does not pull to one side at the
top.
To Next Page
Loading...
