BT RRE200 - Central Information Display - CID; CID LED Symbols

Functions and parameters
Operator compartment
Publication No. Date Valid from serial number T-code
261828-040 2008-08-21 6051502 815, 816
© BT Repair Manual RRE140/160/180/200/250 4 – 19
4.6.4 Central Information Display – CID
The Central Information Display, referred to from now on as “CID”, with
its menu-based information system, is used as the main instrument of
communication between the operator and the truck.
The CID contains coloured LED symbols and a monochrome graphics
display. At the right of the display there is a keypad with the figures 0 to
9 and the buttons "green" (I) and "red" (O).
In logged-out mode the display backlighting is switched off if there has
been no activity for 5
minutes. Once the keypad is activated, the light-
ing is switched on again.
In logged-in mode, the display is always lit.
CID LED symbols
Once the truck is started, the LED symbols of the display come on for a
short time and then go out again.
In emergency driving mode all the symbols flash simultaneously.
a. Travel direction - left.
Flashes when no travel direction is selected, comes on
permanently when travel direction is the same as drive wheel
direction.
b. Parking brake.
Comes on when the parking brake is engaged.
c. Travel direction - right.
Flashes when no travel direction is selected, comes on
permanently when travel direction is the same as fork direction.
d. Stop.
The truck has been stopped due to a critical fault.
e. Cabin tilt.
Cabin tilting is possible (RRE Ergo)
f. Warning.
Comes on when a warning is active.
g. Low battery.
Battery capacity is low: flashing lamp when 10 % remaining, comes
on permanently at 0 %.
h. Extra.
Comes on when an extra hydraulic function is selected.
1
2
3

abcdefgh