BT RRE200 - Placing the Drive Gear in the Truck

Drive gear 2000
General
Publication No. Date Valid from serial number T-code
261828-040 2008-08-21 6051502 815, 816
© BT Repair Manual RRE140/160/180/200/250 10 – 7
10.1.4 Placing the drive gear in the truck
1. Place the gear in a standing position on the floor under the truck.
2. Lower the truck over the gear.
3. Place three screws, M12x110 mm, in the fixing holes to hold the
gear in place.
4. Raise the truck and place spacers under the gear.
5. Lower the truck over the gear.
6. Screw the gear in tight. Tighten to 97 Nm.
7. Raise the truck and place the drive wheel. Hand tighten the nuts as
tight as possible.
8. Lower the truck onto the wheel.
9. Tighten the drive wheel nuts to a torque of 130 Nm.