Drive gear 2000
General
Publication No. Date Valid from serial number T-code
261828-040 2008-08-21 6051502 815, 816
© BT Repair Manual RRE140/160/180/200/250 10 – 3
Removing the drive gear from the truck
1. Undo the locking nuts on the drive wheel.T
2. Use a jack to raise the truck by approximately 16 cm.
3. Chock the truck up.
4. Remove the drive wheel. See the section "Drive wheel, replace-
ment (3530)".
5. Undo the six gear screws.
6. Place a block of wood, approximately 70×70 mm, under the gear.
7. Lower the truck so that the gear is resting on the block of wood.
To Next Page
Loading...
