15 – 12 Repair Manual RRE140/160/180/200/250 © BT
Mast/Lift system 7000
Main mast 1.6-2.5 t (7100)
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
15.1.5 Placing the mast on the truck
1. Attach a lifting device (see the "Tools" section) to the mast and put
the mast in an erect position, suspended in the traverse.
2. If the eccentric cams (e) have been removed from the mast or are
new:
- Lubricate the mast pin (j) with MoS2 grease.
- Thread the eccentric cam (e) onto the pin (j).
- Lubricate the threaded hole in the eccentric cam (e) and screw in
the adjusting screw (h).
- Screw in the locking screw (b) by hand to stop the eccentric cam
falling off during the docking operation.
3. Turn the eccentric cams (e) so that the largest level surfaces attain
a horizontal position facing downwards.
4. Lubricate the cups on the mast attachment (k) in the reach carriage
with MoS2 grease.
b
e
kh
To Next Page
Loading...
