Functions and parameters
Chassis 0000
Publication No. Date Valid from serial number T-code
261828-040 2008-08-21 6051502 815, 816
© BT Repair Manual RRE140/160/180/200/250 4 – 1
4 – Functions and parameters
4.1 Chassis 0000
4.1.1 Driver protection (0840)
Tilt stops
To increase truck capacity, tilt stops are fitted to some trucks. Tilt stops
are also available as an option.
It is, however, permissible to temporarily remove tilt stops when trans-
porting the truck, between different warehouses, for instance; but the
truck may not in this case be used to transport loads.
WARNING!
Reduced stability.
Trucks without tilt stops can tip over, if used to transport loads.
Ensure that tilt stops are refitted at the correct floor distance if they
have been temporarily removed.
The tilt stops are located on the rear corner of the support arm and con-
sist of stops (c), shims (b), bolts (d), and nuts (a) on the inside of the
chassis.
.
a
b
c
c
b
a
d
d
To Next Page
Loading...
