13 – 10 Repair Manual RRE140/160/180/200/250 © BT
Electrical system 5000
Control console (5510)
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
13.2.7 Placing the control console in the
truck
1. Put the wiring harness of the control console back in place. Insert
the connector units behind the panel and push them in towards the
opening near the armrest.
2. Place the control console in the track for the sled.
3. Push the console in until it reaches its rear position.
4. Rotate the catch (f) so that it points to the side.
5. Connect the two contacts (c) under the armrest.
6. Place the cable clamp (d) (10 mm hex).
7. Replace the box (b) under the armrest, and the armrest (a).
e
f
d
a
b
To Next Page
Loading...
