Electrical system 5000
Control console (5510)
Publication No. Date Valid from serial number T-code
261828-040 2008-08-21 6051502 815, 816
© BT Repair Manual RRE140/160/180/200/250 13 – 3
13.2 Control console (5510)
13.2.1 General
The control console is available in two versions, with either four or five
separate controls (potentiometers) or with a multifunction control. In
what follows, there is a description of how to work on a control console
with separate controls.
13.2.2 Replacement/installation of a control
An extra control (a fourth and fifth hydraulic function) can be fitted to the
cable harness already present.
1. Insert a feeler gauge (arrow) on the side of the control console, at
the joint in the panels.
2. Remove the cover (a).
3. Undo the four screws (c) (torx 10) that hold the control.
4. Lift the control up.
5. Disconnect the control from the cable harness.
6. If the symbol/top (b) on a control is to be replaced:
- Using a pair of narrow pliers, press together the two locking pins
that are visible on the underside of the control arm, next to the po
-
tentiometer.
- Pull the top of the control upwards.
- Press the new top tightly into place on the control.
7. Reassemble in reverse order.
a
To Next Page
Loading...
