BT RRE200 - Fitting the Drive Motor to the Truck

Motors 1000
Drive motor (1760)
Publication No. Date Valid from serial number T-code
261828-040 2008-08-21 6051502 815, 816
© BT Repair Manual RRE140/160/180/200/250 9 – 19
9.5.6 Fitting the drive motor to the truck
1. Lubricate the splines on the output shaft of the motor with Klüber-
plex BEM34-132 (226158).
2. Attach a lifting eye to the shaft end of the motor and lift the motor
into place in the truck, paying attention to the splines on the shaft
end.
3. Turn the motor shaft if its output shaft does not fit into the drive gear
input shaft.
4. Tighten the motor. Tightening torque 25 +4/-2 Nm.
5. Connect the power cables of the motor – tightening torque 20 Nm.
6. Connect up the connector unit for the sensor and brake.
7. Place the cap in the centre of the parking brake (2.5 mm allen
screws).