BT RRE200 - Page 237

Hydraulic system 6000
Hydraulic unit (6100)
Publication No. Date Valid from serial number T-code
261828-040 2008-08-21 6051502 815, 816
© BT Repair Manual RRE140/160/180/200/250 14 – 5
14.1.4 Replacing the hydraulic pump
For removal of the pump motor from the truck, See section
“14.1.3 Removing the pump motor from the truck”.
1. Remove the suction connection (b) from the pump.
2. Remove the two screws (a) (6 mm allen screws).
3. Separate the hydraulic pump (c) from the motor (d).
4. Place the suction connection on the new pump unit.
5. Place a new O-ring on the pump between the pump and pump mo-
tor.
6. Place the pump unit on the pump motor.
7. Tighten the screws.
Mom 2: s = 6, n = 2
× n
s mm
a
c
bd
× n
s mm
Mom 7: s = 6, n = 2
23 ±6 Nm