15 – 4 Repair Manual RRE140/160/180/200/250 © BT
Mast/Lift system 7000
Main mast 1.6-2.5 t (7100)
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
12. Undo and remove the screws (a) (19 mm allen screws) of the bot-
tom attachment. The 2.5 ton mast has two screws, and other masts
one screw per side.
IMPORTANT!
Mark the shims as being from the right or left respectively, so that the
correct mast incline is obtained when refitting.
13. Undo the screws (b) (14 mm allen screws) approximately one turn.
14. Remove the screws (c) (10 mm allen screws) and the locking rings
(d).
15. Mark (with a scribe or centre punch) the eccentric cam in relation to
the reach carriage, to facilitate refitting and adjustment.
16. Turn the eccentric cams (e) (60 mm hexagonal screw) so that the
large level surfaces (f) are facing downwards.
17.
18. Lift out the mast.
a
a
b
c
d
e
To Next Page
Loading...
