LEARN
SMART MATRIX - 2-52 -
LEARN
The LEARN function (which can be activated pressing the button
) allows you to carry out a learning
cycle during which the system detects and memorizes the number of sensors (nnnn) inside which the yarn is
regularly running, excluding the sensors in alarm status.
At the end of learning cycle, after the time interval defined in Delay Control, the system automatically
activates the Control mode and continuously controls the regular running of yarn inside all the “nnnn”
sensors detected during the learning phase.
The LEARN function must be activated with the Machine Stationary.
If you press the button
when the machine is working, then the LEARN function will be “reserved”
(P_LEARN shown on display) and it will be actually carried out only after the machine stop and subsequent
restart.
Press the LEARN activation button.
Reply YES to the START LEARN? prompt.
At the end of the function, the number of detected sensors (nnnn)
will replace the - - - - indication.
To Next Page
Loading...
