LinkStation User Manual 143
Chapter 3
NAS Navigator2
NAS Navigator2 is a utility program that makes it simple to display the Web Admin interface, change
its IP address or check its hard drive.
Windows
If you set up the LinkStation with the LinkNavigator CD, NAS Navigator2 is installed and congured
to run automatically in the system tray at startup.
You can launch NAS Navigator2 in either of the following ways:
• Double-click the icon on the desktop.
• Click [Start] - [(All) Programs] - [BUFFALO] - [BUFFALO NAS Navigator2]-[BUFFALO NAS Navigator2].
Screen:
Clicking a LinkStation's icon will display its total capacity, capacity being used, [IP Address],
[Workgroup], [Subnet Mask], [Default Gateway], [MAC Address], and [Firmware] version.
To Next Page
Loading...
