Buffalo LS-VL - Page 199

LinkStation User Manual 198
Appendix
The Info/Error LED blinks red to indicate an error.
The error may be identied by the pattern of blinking.
Note:
The error may also be viewed from NAS Navigator2.
Error code Descriptions
E04 The rmware is corrupted. Contact Bualo technical support for assistance.
E10 The LinkStation is running on the UPS battery due to a power outage. The system
will now be shut down safely. Check that power is being supplied to the UPS, and if
there are no problems, turn on the LinkStation.
E11 An error occurred in the fan speed. Check that no foreign objects or dust are
clogging the fan. If any foreign objects or dust are found, use a pair of tweezers, air
duster, or other tool to remove them.
If the error is displayed again, contact Bualo technical support for assistance.
E12 System temperature has exceeded the maximum safe value. Do not place objects in
the area around the LinkStation.
Also, move the LinkStation to a cooler location.
E13 An error occurred in the RAID array. It will run in degraded mode until the error is
corrected. Replace the failed drive indicated by the red LED as soon as possible. After
replacement, rebuild the RAID array after starting the LinkStation.
E14 The RAID array cannot be mounted. Run the RAID array disk check in the
LinkStation's Web Admin interface.
E15 The bad sectors in the hard drive have reached a dangerous level. Replace the hard
drive indicated by the red LED.
E16 Unable to nd the hard drive. The drive may be disconnected or may have failed.
After shutting down, reinstall the hard drive.
E22 Mounting of hard drive failed. Format the hard drive. After formatting and rebooting,
if the error still appears, replace the drive.
If this error is displayed again, contact Bualo technical support for assistance.
E23 An error occurred, so the hard drive was removed from the RAID array. Replace the
hard drive indicated by the red LED.
E30 The hard drive may be damaged. Replace the hard drive indicated by the red LED.
Place Status
10s place The LED illuminates for 1.0 second every 0.3 seconds.
The number of ashes is the tens place of the error code.
1s place The LED illuminates for 0.5 seconds every 0.3 seconds.
The number of ashes is the ones place of the error code.