Buffalo LS-VL - Page 202

LinkStation User Manual 201
Appendix
Info/Error LED
The Info/Error LED blinks orange when it has a message. The message is coded by the pattern of
blinking.
Note:
The messages are also available (uncoded) in NAS Navigator2.
Information code Descriptions
I10 System temperature has exceeded the maximum safe value. Move the
LinkStation to a cooler location. Do not place objects in the area around the
LinkStation.
I11 The bad sectors in the hard drive may have reached a dangerous level.
I12 Operating in degraded mode.
I13 Formatting the RAID array.
I14 Checking the RAID array.
I15 Examining the error status of the RAID array. Transfer speeds are slower
during the examination process.
I16 Creating the RAID array.
I17 Resyncing the RAID array. Transfer speeds are slower during the resyncing
process.
I18 Rebuilding the RAID array. Transfer speeds are slower during the rebuilding
process.
I19 Writing 0s to the RAID array, erasing all data.
I20 Checking the hard drive.
I21 Checking the hard drive.
I22 Erasing the data for the hard drive.
I25 Updating the LinkStation rmware. Do not turn o the power during the
updating process.
I26 Initializing all settings in the Web Admin interface.
I27 Checking a USB hard drive.
Place Status
10s place The LED illuminates for 1.0 second every 0.3 seconds.
The number of ashes is the tens place of the information code.
1s place The LED illuminates for 0.5 seconds every 0.3 seconds.
The number of ashes is the ones place of the information code.