261 . . .
–
–
Section 2
CAUTION
Sitting in a reclined position
when your vehicle is in motion
can be dangerous. Even if you
buckle up, your safety belts
can't do their job when the
seatback is excessively reclined.
Improperly positioned safety
belts may cause neck injury or
injury to the vulnerable organs
in the abdominal area.
For proper protection when the
vehicle is in motion, have the
seatback in the upright
position.
Then, sit well back in the seat
and wear your safety belt
properly.
POWER LUMBAR CONTROL (IF
EQUIPPED)
The control is located on the side
of each front seat.
Push the front of the switch to
increase lumbar support or the
rear of the switch to decrease it.
POWER LUMBAR AND SIDE
BOLSTER CONTROLS (IF
EQUIPPED)
Power Lumbar Control
Press and hold the top of the
control  to increase lumbar
support at the top of the seatback
and to decrease lumbar support at
the bottom of the seatback.
Press and hold the bottom of the
control  to decrease lumbar
support at the top of the seatback
and to increase lumbar support at
the bottom of the seatback.
A
C
B
AKENG40_CTS Page 261 Wednesday, July 23, 2008 11:47 AM
To Next Page
Loading...
Need help?
General
