Service and Maintenance
. . . 414
After a power loss, such as
disconnecting the battery or
removing the maxifuses in the fuse
block, the following steps must be
performed to calibrate the
electronic throttle control. If this is
not done, the engine will not run
properly.
1. Turn the ignition on but do
not start the engine.
2. Leave the ignition on for at
least three minutes so that the
electronic throttle control will
cycle and relearn its home
position.
3. Turn the ignition off.
4. Start and run the engine for at
least 30 seconds.
Vehicle Storage
If the vehicle is driven infrequently,
disconnect the cable from the
negative ("-") terminal of the
battery to prevent discharge.
If the vehicle is going to be stored
for an extended period of time,
disconnect the cable from the
negative ("-") terminal of the
battery or use a battery trickle
charger to prevent discharge.
Air Cleaner/Filter
The engine air cleaner/filter
assembly is located on the left side
of the engine compartment near
the front.
A disposable air filter element is
contained in the air cleaner.
Inspect and change the filter at the
intervals recommended in your
Maintenance Schedule.
AKENG40_CTS Page 414 Wednesday, July 23, 2008 11:47 AM
To Next Page
Loading...
Need help?
General
