Problems on the Road
. . . 508
• Compressor kits not equipped
with a selector switch:
- Rotate the sealant canister so
that the sealant filling hose is
aligned with the slot in the
compressor.
- Push the sealant canister
down and rotate the canister
clockwise.
-Wrap the sealant filling hose
around the air compressor
channel.
- Push the air compressor
inflator hose onto the sealant
canister inlet and push the
lever down.
Stow the tire sealant and
compressor kit in the vehicle.
See your dealer for more
information.
■ IF YOUR VEHICLE GETS
STUCK
If your vehicle gets stuck in sand,
mud, ice or snow, you will need to
spin the wheels.
Do not, however, spin the wheels
too fast.
The traction control system can
often help to free a stuck vehicle.
However, you may need to rock
the vehicle to free it.
See "Rocking Your Vehicle" later in
this section.
CAUTION
If you let your tires spin at high
speed, they could explode. You
or others could be injured. Also,
the transmission or other parts
of the vehicle could overheat
and cause an engine fire or
other damage.
If the vehicle gets stuck, spin
the wheels as little as possible.
Do not spin the wheels above
55 km/h (35 mph), as shown
on the speedometer.
For information about using tire
chains on your vehicle, see "Tire
Chains" under "Tires" in Section 4.
AKENG40_CTS Page 508 Wednesday, July 23, 2008 11:47 AM
To Next Page
Loading...
Need help?
General
