Starting and Operating Instructions
. . . 338
To end remote-start engine
runtime without transitioning to
normal vehicle operation, do any
of the following:
• Aim the transmitter at the
vehicle and press the
remote-start button until the
parking lights turn off.
Your transmitter’s range
may be less while the vehicle is
running.
•Turn on the hazard warning
flashers.
•Turn the ignition on, and then
off.
Do not use the remote-start
feature if your vehicle is low on
fuel.
The vehicle could run out of fuel.
NOTE:
Laws in some regions
may restrict the use of remote-
starters.
Check local and national
regulations for any require-
ments.
The remote-start feature will not
operate under any of the following
conditions:
• The ignition is not turned to
the off position.
• The vehicle’s hood is open.
• The transmitter is inside the
vehicle.
• There is an emission control
system malfunction.
• The engine coolant
temperature is too high.
• The engine oil pressure is low.
• The remote-start feature is not
enabled.
• An unauthorized vehicle entry
or a vehicle theft was
attempted.
AKENG40_CTS Page 338 Wednesday, July 23, 2008 11:47 AM