477 . . .
–
–
–
–
–
Section 5
If coolant is visible in the surge
tank:
If coolant is visible in the tank but
the level is not up to the FROID/
FULL COLD mark, wait a while for
the engine to cool, then add a
50/50 mixture of clean water
and DEX-COOL
®
coolant at the
coolant surge tank. See "Engine
Coolant" in the "Service and
Maintenance" section.
If no coolant is visible in the
surge tank:
Add a 50/50 mixture of clean
water and DEX-COOL
®
coolant at
the coolant surge tank. See
"Engine Coolant" in the "Service
and Maintenance" section.
NOTICE
This vehicle has a specific cool-
ant fill procedure. Failure to
follow this procedure could
cause the engine to overheat
and be severely damaged.
Here's how to add coolant to the
coolant tank:
1. The vehicle should be parked
on a level surface.
2. To remove the cap when the
cooling system is no longer
hot, turn it slowly one quarter
turn to the left and then stop.
If you hear a "hiss", wait for
that to stop. The "hiss" means
there is still some pressure left.
Then, remove the cap.
3. Fill the coolant tank with the
right mix up to the FROID/
FULL COLD mark.
AKENG40_CTS Page 477 Wednesday, July 23, 2008 11:47 AM
To Next Page
Loading...
Need help?
General
