âš«
The ePMP MP 3000 MicroPOP module hardware, part numbers, mounting equipment, and
specifications are described under ePMP MP3000 MicroPoP.
âš«
The Force 425 module hardware, integrated description, part numbers, mounting equipment, and
specifications are described under Force 425.
âš«
The Force 400C module hardware, integrated description, part numbers, mounting equipment,
and specifications are described under Force 400C.
âš«
The Force 4600C module hardware, integrated description, part numbers, mounting equipment,
and specifications are described under Force 4600C.
âš«
The Force 4525 module hardware, integrated description, part numbers, mounting equipment, and
specifications are described under Force 4525.
âš«
The Force 4525L module hardware, integrated description, part numbers, mounting equipment,
and specifications are described under Force 4525L.
âš«
The Force 4625 module hardware, integrated description, part numbers, mounting equipment,
and specifications are described under Force 4625.
âš«
The power supply hardware, part numbers, and specifications are described under Power supply.
âš«
Cable standards and lengths are described under Ethernet cabling.
âš«
Surge suppression requirements and recommendations are described under the Surge
suppression unit.
âš«
GPS synchronization generation information are described under the cnPulse sync generator.
Site Planning
Conduct a site survey to ensure that the proposed sites meet the requirements defined in this section.
Site installation
An ePMP site typically consists of a high supporting structure such as a mast, tower, or building for the
devices.
Find a location for the device that meets the following requirements:
âš«
The equipment is high enough to achieve the best radio path.
âš«
People can be kept a safe distance away from the equipment when it is radiating. The safe
separation distances are defined in Calculated distances and power compliance margins.
âš«
The equipment is lower than the top of the supporting structure (tower, mast, or building) or its
lightning air terminal.
âš«
There is one Ethernet interface, a copper Cat5e connection from the device to the power supply,
and network terminating equipment.
Grounding and lightning protection
Structures, equipment, and people must be protected against power surges (typically caused by
lightning) by conducting the surge current to the ground via a separate preferential solid path. The actual
degree of protection required depends on local conditions and applicable local regulations. To
adequately protect an ePMP installation, both ground bonding and transient voltage surge suppression
are required.
To Next Page
Loading...
Need help?
General
