Canon EOS A2E - Depth-of-Field AE Mode; DEP Mode Setup

5. DEP (Depth-ot-Field AE)
Th is mode places everything between two
freely set points
in the foreground and back-
ground within the zone of focus.
1) Set the command dial to DEP.
2) Select the desired AF frame using the ma-
nual focusing point selection procedure
(refer to page 25).
3) Place the
AF frame on the nearest point
you want
in focus (point A) , then press the
shutter button.
* When the in-focus indicator and "dEP 1"
light up
in the viewfinder, remove your
finger from the shutter button.
4) Place the AF frame on the farthest point
you want
in focus (point B), then press the
shutter button again.
* When the in-focus indicator and "dEP 2"
light up
in the viewfinder, remove your
finger from the shutter button.
* Po ints A and B can be reversed if
desired.
45