Appears after performing network setup and clicking Set to close the window.
• Requires Setup•
Indicates the printer is required to perform Wi-Fi setup.
Performing/Changing Wi-Fi Settings
• Not Set•
Indicates the printer cannot be used on network, or IPv6 is disabled. Specify an IP address or
enable IPv6 on Network Settings....
Performing/Changing Wi-Fi Settings
• IP Address Overlap•
Indicates the IP address is duplicated to another printer.
• Unknown•
Indicates the printer recognized as Available in the past cannot be used currently.
Note
• If USB is selected from the pulldown menu on the toolbar, nothing is displayed.•
D: IP Address
Displays the printer IP address. Nothing is displayed if the printer status is Requires Setup.
Note
• If USB is selected from the pulldown menu on the toolbar, "-" is displayed.
E: Location
Displays the printer location if it is registered. Nothing is displayed if the printer status is Requires
Setup.
Note
• If USB is selected from the pulldown menu on the toolbar, nothing is displayed.
Assigning Printer Information
F: Connection Method
Displays printer connection method (wired LAN, Wi-Fi, or USB).
Note
• If USB is selected from the pulldown menu on the toolbar, USB is displayed.
• If the printer supports both of the LAN connection methods, the printer is recognized as two
printers and they are displayed separately. (The same numbers are displayed on Serial Number
(Last 5 Digits).)
• If the printer does not support wired LAN, wired LAN is not displayed.
• If you are using Wi-Fi Connection Assistant on the computer which does not support Wi-Fi, Wi-Fi
is not displayed.
G: Setting Method
Displays printer setting method.
• Auto•
111
To Next Page
Loading...
Need help?
General