Repairing Your Printer
This section describes how to transport the printer for repairing it.
Important
• You cannot take ink out of ink tanks.•
• Make sure the tank caps of ink tanks are closed securely. If the tank caps are open, close the tank caps•
properly.
• Press the ON button to turn off the printer with the print heads installed. The printer protects the print•
heads by covering them automatically to prevent them from being dried.
• Do not remove the print heads. Doing so may cause the ink to leak.•
• If the inside of the printer becomes dirty, clean with a soft cloth that gets wet with water and squeezed•
firmly.
• When transporting the printer, pack the printer in a plastic bag so that ink does not leak.•
• Pack the printer in a sturdy box so that it is placed with its bottom facing down, using sufficient•
protective material to ensure safe transport.
• Do not tilt the printer; otherwise, ink may leak. When a shipping agent is handling transport of the•
printer, have its box marked "THIS SIDE UP" to keep the printer with its bottom facing down.
• Mark also with "FRAGILE" or "HANDLE WITH CARE".•
• Please handle with care and ensure the box remains flat and NOT turned upside down or on its side, as•
the printer may be damaged and ink in the printer may leak.
Make Sure Ink Valve is Closed
1.
Make sure the status light is not lit.
1.
647
To Next Page
Loading...
Need help?
General