Message Is Displayed
This section describes some of the messages.
If a message is displayed on the printer's touch screen, see below.
Message Is Displayed on Printer's Touch Screen
If a message is displayed on the computer, see below.
Error Regarding Automatic 2-sided Printing Is Displayed
Error Regarding Power Cord Being Unplugged Is Displayed (Windows)
Writing Error/Output Error/Communication Error (Windows)
Other Error Messages (Windows)
Message Is Displayed on Printer's Touch Screen
Check the message and take appropriate action.
• Power was not turned off correctly the last time. Press the button when turning power off.•
The printer may have been unplugged while the power was still on.
Select OK on the printer's touch screen to cancel the error.
Refer to Turning the Printer On and Off for the correct way to turn the power off.
• Cannot connect to the server. Please wait a while and try again.•
The printer cannot connect to the server due to a communication error.
Select OK on the printer's touch screen to cancel the error and try again after a while.
• Check the page size and tap [OK].•
The size of the loaded paper is different from the paper size set in Fax paper settings.
Select OK on the printer's touch screen to cancel the error.
Select Function list in Fax, check Page size, Type and Paper src in Fax paper settings, and then
reload the paper accordingly.
• Replace the receiver.•
The handset is not placed in the handset cradle correctly.
Replace the handset correctly.
Note
• See Message for Faxing Is Displayed on Fax Standby Screen for the message displayed on the fax
standby screen.
Error Regarding Automatic 2-sided Printing Is Displayed
Check
See Automatic 2-sided Printing Problems and take the appropriate action.
644
To Next Page
Loading...
Need help?
General